TEKLYNX CODESOFT 10 Runtime RFID Guide de l'utilisateur télécharger pdf (Page 9)

Introduction

License activation

Your software can be activated using a software key (an activation code) or a hardware key (a dongle).

The dongle is a small electronic device that you plug into your PC’s parallel or USB port before launching the

software. Without the hardware protection key, the program will run in evaluation mode. You will not be able to

save your labels, 'e' will be replaced with 'x', '0' will be replaced with '5', and images will be crossed when

printing.

The software key is an activation code that is requested by the Activation Wizard when you launch the software

for the first time or for as long as you are running a trial version. If you are using a trial software key, you will

be given 100 executions or 30 days to try the product with all of the product’s functionality available to you.

Note: When you launch the application, if the protection key does not correspond to your product version, a

dialog box will appear providing the necessary instructions.

You must first run your labeling software installation and then activate or connect the protection key to your

computer.

Note: If you have purchased a Network license, first install Network & User Utilities to install the license

server. On each workstation, install your product. To connect workstations to the network, you must start the

software in trial mode and select Network Administration.

Hardware key protection

If you have purchased the software with a dongle, you may choose between a USB or parallel port dongle.

Connecting the parallel key:

If you need to use a printer on the same parallel port, simply plug it into the software protection key. It may be

necessary to turn the printer on in order for the software protection key to be recognized.

Connecting the USB key:

When you use a USB key and have multiple USB ports, it does not matter which port you use. If you do not

have an available USB port, you can use a USB expander hub. USB devices are hot-swappable, meaning you

can plug and unplug them into the bus any time, without restarting the PC.

Note: Drivers can be installed while the application is running. However you must restart your labeling

software for the changes to take effect.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 48 49

Pas de commentaire

TEKLYNX CODESOFT 10 Runtime RFID Guide de l'utilisateur Page 9